|Pagina PrincipalaLED Flex si ModulePenn Elcom Led T wire for connection of 8mm strips Ip20 LEDCTWIRE8SC||
Penn Elcom Led T wire for connection of 8mm strips Ip20 LEDCTWIRE8SC £0.50
Comus 2pin wire for connecting up to 3x 8mm LED strips in a T shape
The T shape wired can be used with up to three in-line joiners (LEDCLJ2PIN8 or LEDCLJD2PIN8) to allow a quick connection of up to three LED strips.
Easy to fit allowing solderless connection. Just unclick the upper part on each free end of the joiners then carefully push each end of the wire inside the joiners until the PCB pad fits below the 2 pins.
Always take note to ensure correct polarity before powering the strips.
This wire can carry a max. current of 3A (so 72W at 24V or 36W at 12V).
Fixing - we strongly recommend the use of a double adhesive tape underneath the joiners or the use of silicone. This will fix the devices in place protecting the start of the LED tape on the long run.
Rated current: 3 A
Max wattage (12/24V): 36/72 W
Compatible joiners (board-to-board connectors): LEDCLJ2PIN8 or LEDCLJD2PIN8
Cable rated insulation voltage: <25 V
Width: 16 mm
Length: 24 mm
Height: <1 mm
Quantity: sold individually
Ati vazut un pret mai mic in alta parte? Penn Elcom Online va face tot ce e posibil pentru a oferi un pret egal, doar apasati mai jos
Jennifer de la United States Cere
Could you tell me if you have a 3D model available for this part so I can place it into my next higher assembly?